AB-Pillar Protection Film for Tesla Model 3 Highland / Model Y Juniper/ Model YL
Model 3 Highland 2024+ · Model Y Juniper 2025+ · Clear TPU
AB-Pillar PPF Invisible. Precise. Durable.
Pre-cut TPU protection film engineered for Model 3 Highland and Model Y Juniper AB-Pillar — guards factory paint against daily contact damage without changing the look of your car.
Performance
Material Performance
Premium TPU with a nano self-healing coating — engineered to absorb daily impact and recover from light surface marks over time.
Heat-Activated Recovery
Minor scratches and scuffs on the topcoat recover when warmed by sunlight or mild heat — keeping the film looking new over years of daily use.
No Yellowing Over Time
Ultra-transparent film blends invisibly with your paint. Formulated to resist UV-induced yellowing and edge lifting.
Repositionable Adhesive
Tear off and reapply repeatedly without leaving adhesive residue or damaging the factory paint surface.
Protect & Forget
No special care required after installation. The film forms a durable physical barrier against dust, sticky contaminants, and road grime — just drive.
Fitment
Compatibility & Package Contents
Two variants available — each pre-cut to match the exact door corner profile of its respective model.
Not sure which version you have? Contact us with your model year and sales region before ordering.
Installation
3-Step Application
Clean the Surface
Wipe the door corner area thoroughly with an isopropyl alcohol wipe. Remove all dust, wax, and grease before applying.
Align & Press
Peel the backing and position the film over the corner. Press firmly from the centre outward using the squeegee card to eliminate air bubbles.
Cure & Drive
Allow 48 hours before washing. If small edge bubbles remain, lightly dampen with water only and re-squeegee toward the edge.
Pro tip
Install in a warm, dust-free environment. Warming the film slightly with a heat gun on a low setting helps it conform around tight corner radii without lifting edges.
FAQ
Common Questions
Which Tesla models does this fit?
This kit covers Model 3 Highland (2024+) and Model Y Juniper (2025+) — the pre-refresh generations.
How many pieces are included?
The Model 3 Highland variant includes 4 pieces (full set of door corner protectors). The Model Y Juniper variant includes 4 pieces (full set). Each piece is pre-cut to match the exact panel geometry of its model — no trimming required.
Will the film be visible after installation?
No. The crystal-clear high-gloss finish is virtually invisible once installed and properly pressed. There are no visible edges under normal lighting or viewing angles.
Can I remove and reapply the film if I make a mistake?
Yes. The film can be torn off and reapplied repeatedly without leaving adhesive residue, provided you reapply within the first few minutes before the adhesive fully bonds to the surface.
How long does the film last, and is any maintenance required?
The film is designed to last several years under normal use. No special maintenance is required — wash your car as normal. Avoid prolonged contact with harsh solvents or abrasive polishes, and do not run through a car wash within 48 hours of installation.