One Piece Dashboard Cover & Door Trim Set | Matte Carbon Fiber or Matte Black for Tesla Model Y (2020-2024) & Model 3 (2021-2023)
COVERS THE WOOD AND WHITE DASH TRIM, NO TOOLS
Fits Model Y 2020 to 2024 and Model 3 2021 to 2023. Choose your style above.
Lose the Wood Trim and Give Your Dash a Clean, Modern Look
Not everyone loves the wood or white strip that runs across the dash and into the front doors. This set covers the dash strip and both front door trims in one matched finish, so the whole front cabin flows together. It is molded to the factory panels and sticks right over them, no tools and no removing anything.
✓ Covers the full dash strip and both front door trims
✓ One piece dash option with no seam across the dashboard
✓ Matte finish that cuts glare and hides fingerprints
✓ Molded to the factory trim for a clean, flush fit
✓ Pre applied tape, no drilling, no trim removal
Choose Your Style
Matte Carbon Fiber, One Piece Dash: a single seamless dash cover plus left and right front door trims, matte carbon fiber pattern.
Matte Black, One Piece Dash: the same seamless one piece set in a clean matte black.
Matte Black, Two Piece Dash: the budget option. The dash cover comes in two sections that meet in the middle, plus both front door trims, in matte black.
Specifications
MaterialABS plastic
FinishMatte carbon fiber pattern or matte black (not real carbon fiber)
MountingPre applied adhesive tape
In the boxDash cover (one or two piece) and left and right front door trim covers
FITMENT, READ BEFORE ORDERING
One piece versions fit: Model Y 2020 to 2024 and Model 3 2021 to 2023
Two piece version fits: Model Y 2020 to 2023 and Model 3 2021 to 2023
Does NOT fit: Model 3 2017 to 2020, Model 3 Highland (2024+), Model Y Juniper (2025+)
Not sure? Text a photo of your dash to (310) 626-3118.
How to Install
1. Clean the dash and door trim with an alcohol wipe and let it dry fully.
2. Dry fit each piece to confirm alignment.
3. Warm the tape with a hair dryer, peel the backing and press from the center out to the edges.
4. Hold the ends firmly for 60 seconds.
5. Park in the shade for the first 24 hours so the adhesive fully sets.
Common Questions
One piece or two piece?
The one piece dash has no seam across the dashboard, so it looks more like a factory part. The two piece is the lower cost option with a joint in the middle.
Can I remove it later?
Yes. Warm the tape with a hair dryer and peel slowly. Any residue cleans up with adhesive remover.
Will it hold up in summer heat?
Yes, when installed on a clean, dry surface and left to cure for 24 hours. Avoid long direct sun right after install.
Questions?
Email support@evbandit.com or text (310) 626-3118.