Carbon Fiber Look Interior Trim Covers | Model S & Model X 2016–2020
PEEL AND STICK, NO DRILLING, NO TOOLS
Give Your Model S or Model X Interior the Carbon Look, One Piece or the Whole Cabin
The piano black and plain plastic trim in the pre refresh Model S and Model X scuffs, shows every fingerprint and ages fast. These carbon fiber look covers are molded to the factory parts and stick right over them, so you get a sportier cabin and a protective layer over the trim you touch every day. Pick the piece you want, or build out the full set.
✓ Molded to the factory trim for a clean, flush fit
✓ Carbon fiber look finish over durable ABS
✓ Protects the original trim from scratches, dust and fingerprints
✓ 3M adhesive backing: no drilling, no cutting, no tools
✓ Does not block buttons, vents, the screen or cup holders
Choose Your Piece
Dashboard Trim (3 pcs): covers the center console panels below the touchscreen
Rear Air Vent Cover (2 pcs): frames the rear seat air vents on the back of the console
Steering Wheel Trim (1 pc): carbon look accent on the steering wheel frame
Cup Holder Covers (2 pcs): wraps the center console cup holder surround
Window Switch Panel Covers (4 pcs): one for each door's window switch panel
Model S Inner Door Trim: carbon look strips for the Model S inner door panels
Model X Inner Door Trim: carbon look strips for the Model X inner door panels
Specifications
Material: ABS with carbon fiber look finish
Mounting: 3M adhesive tape, pre applied
Install time: minutes per piece
FITMENT
Dashboard Trim: Model S 2014 to 2020, Model X 2016 to 2020
Model S Inner Door Trim: Model S 2016 to 2020 only
Model X Inner Door Trim: Model X 2016 to 2020 only
All other pieces: Model S and Model X 2016 to 2020
Does not fit the 2021+ refreshed Model S or Model X with the yoke and horizontal screen. Not sure? Text a photo of your interior to (310) 626-3118.
How to Install
1. Clean and fully dry the factory trim surface.
2. Dry fit the piece first to confirm alignment.
3. Peel the red backing and press into place.
4. Hold firm pressure for 2 minutes, especially on the edges.
5. Keep it dry for 72 hours while the adhesive cures. In cold weather, warm the tape with a hair dryer first.
Common Questions
Is this real carbon fiber?
No. It is ABS plastic with a carbon fiber look finish. That keeps it light, affordable and easy to install.
Can I remove it later?
Yes. Warm the adhesive with a hair dryer and peel slowly. Any residue cleans up with adhesive remover.
Want the full carbon interior?
Order each piece you want in the same checkout. They are made to match.
Questions? Email support@evbandit.com or text (310) 626-3118.